TEPCO has announced their plan to remove the cover of unit 1 so that debris on the refueling floor can be cleaned off. This work will enable viewing of the spent fuel pool and the condition of the reactor well. The work has come under increased scrutiny after it was discovered that similar demolition work at unit 3 had caused contamination up to 50km from the plant due to the wind blowing radioactive building dust.
TEPCO’s plan for dismantling the mess on the refueling floor hopes to cut down on releases to the environment. They challenge may be that the releases from unit 3, even though they were considerable didn’t cause readings at the site boundary or nearby that caused anyone to take notice. Only an in plant reading near a bus stop caused an alarm, along with two contaminated workers.
The plan will involve first removing portions of the roof cover building. Upper sides will be removed but the lower sides near the first floor will be left on. A wind break type sheeting will be installed around the refueling floor as can be seen in the illustration below as the green band on the building.
A combination of a vacuum system, the fixative sprayer and a water spray unit will be used during demolition to try to keep dust down. TEPCO did not explain where they water will run off to or how much water they anticipate using during the process.
TEPCO cited their monitoring post system as a feature for tracking releases. The system appears to be the same one in place during the unit 3 demolition work. TEPCO does plan to re access the tactics for demolishing of the top of unit 1 during the process to see if adjustments are needed.
Original Japanese TEPCO handout: http://www.tepco.co.jp/nu/fukushima-np/handouts/2014/images/handouts_140717_05-j.pdf
This article would not be possible without the extensive efforts of the SimplyInfo research team
Join the conversation at chat.simplyinfo.org
© 2011-2022 SimplyInfo.org, Fukuleaks.org All Rights Reserved Content cited, quoted etc. from other sources is under the respective rights of that content owner. If you are viewing this page on any website other than http://www.simplyinfo.org (or http://www.fukuleaks.org) it may be plagiarized, please let us know. If you wish to reproduce any of our content in full or in more than a phrase or quote, please contact us first to obtain permission.