Besides gathering data in this area, this work will also help provide data to be used for designing a method to remove the melted fuel (corium).
The robot dubbed Scorpion will be sent in through the CRD hatch with a task of entering the pedestal region below the reactor. Previous scope inspections confirmed a partial failure of the bottom of the reactor vessel.
So far work has taken place that cleaned the area around the CRD hatch and cut a hole in the metal CRD hatch cover. Robots were used to clean the area, pour a layer of cement then lay down sheets of steel plate. After this was completed, the robotic drilling rig was used to connect to the CRD hatch and drill a hole large enough for the next set of equipment. Extra steps were taken to contain any debris or contamination that could leak out.
With this preparation work completed, the steps to conduct the actual inspection will include inserting another scope to check conditions. Then a small debris removal bot will go in to water blast any small debris that could cause problems for the Scorpion robot. After this the Scorpion robot will be deployed inside the pedestal. The goal is to have the Scorpion robot travel along the metal grate platform inside the pedestal.
Concerns remain about the robot’s ability to withstand the high radiation levels inside containment. Levels found years back were 75 Sieverts/hour. Levels inside the pedestal could be much higher. There are also concerns about the ability of the camera to clearly view for navigation. The on board lighting and expected humidity should make most work visible but slightly cloudy in appearance.
The inspection work appears to be scheduled for some time after March 2017.
This article would not be possible without the extensive efforts of the SimplyInfo research team
Join the conversation at chat.simplyinfo.org
© 2011-2018 SimplyInfo.org, Fukuleaks.org All Rights Reserved Content cited, quoted etc. from other sources is under the respective rights of that content owner. If you are viewing this page on any website other than http://www.simplyinfo.org (or http://www.fukuleaks.org) it may be plagiarized, please let us know. If you wish to reproduce any of our content in full or in more than a phrase or quote, please contact us first to obtain permission.