The unit 1-2 vent tower at Fukushima Daiichi is the most dangerous location on site outside of the reactor buildings. Even years later the radiation levels at the base of this tower are too high to go near without heavy shielding. The tower was discovered to have structural damage, a combination of rust, degradation and damage from the explosion of unit 1 back in 2011.
Work has been underway to cut down the tower, section by section.
The first section at the top of the vent tower was cut in late August.
Around September 17th a problem with the wifi communications system was caused by water leaking into a wifi antenna on the cutting rig.
Work began around September 18th to cut the next section of vent tower. Work was completed around September 26th. There was a work delay due to typhoon Tapah.
Around October 22nd the third vent pipe section was cut and removed.
Dismantling of the 4th section of the vent tower began on October 27th.
Half of the vent tube was cut the first day. As workers prepared to cut the outer scaffolding a holding clamp failed and fell to the ground. The clamp landed at the base of the vent tower that is off limits due to high radiation. A replacement clamp was installed on the cutting rig from spare parts.
TEPCO plans to cut down the upper portions of the vent tower including 16 sections of vent pipe, 3 sections of trussing with vent pipe and 4 sections of scaffolding. They have just begun working on the sections covered in scaffolding.
The lower sections of the tower currently do not have a removal plan. The upper sections were the highest risk of failure. Removal of the upper sections lowers the probability of a tower failure.
This article would not be possible without the extensive efforts of the SimplyInfo research team
Join the conversation at chat.simplyinfo.org
© 2011-2018 SimplyInfo.org, Fukuleaks.org All Rights Reserved Content cited, quoted etc. from other sources is under the respective rights of that content owner. If you are viewing this page on any website other than www.simplyinfo.org (or www.fukuleaks.org) it may be plagiarized, please let us know. If you wish to reproduce any of our content in full or in more than a phrase or quote, please contact us first to obtain permission.