The bus used as a remote command center for the work to cut down the unit 1-2 vent tower took an unscheduled trip in November.
The bus was being prepared for use as work to dismantle the vent tower was to resume. The ignition key was left on the bus and for an unexplained reason a worker started the engine. Due to a problem in the electrical system the bus took off and they were unable to stop it. The foot brake, side break and clutch all failed to stop the bus. The bus was finally stopped by cutting the engine.
The bus is hooked up via electrical cables to a nearby pair of generators that provided power to the equipment inside the bus. The unexpected movement of the bus severed the power cables. TEPCO states that the engine power is not needed to operate any of the equipment on the bus. The key for the bus ignition will now be stored in an administration office to prevent another incident. TEPCO did not mention if the electrical hook up has since been repaired or if there would be a delay in preparing the bus for further use.
TEPCO report translated to English (machine translated)
This article would not be possible without the extensive efforts of the SimplyInfo research team
Join the conversation at chat.simplyinfo.org
© 2011-2018 SimplyInfo.org, Fukuleaks.org All Rights Reserved Content cited, quoted etc. from other sources is under the respective rights of that content owner. If you are viewing this page on any website other than http://www.simplyinfo.org (or http://www.fukuleaks.org) it may be plagiarized, please let us know. If you wish to reproduce any of our content in full or in more than a phrase or quote, please contact us first to obtain permission.