This TEPCO photograph of the pedestal area of unit 5 at Fukushima Daiichii. Unit 5 is the same design as units 1-4 and was built last of the BWR units at Fukushima Daiichi. The photograph is interesting in that it shows a rarely photographed area below the reactor vessel. This area is likely heavily damaged in units 1-3 as the fuel melted out of the reactor vessels. The equipment seen within the pedestal is the underside of the control rod systems.
Some repairs have been made. One section of pipe is patched with a piece of plastic sheeting and duct tape. Another with some sort of patch and some sort of clear plastic film or tape. The patched section is then supported with wire. The systems inside the pedestal are the control rod systems, what allows them to control and stop the reactor. The amount of corrosion on bolts and other parts of the system is concerning. This is the newest of the BWR units, what was the condition of the much older units before the accidents?
Duct tape on control rod system pipes. Notice the rust on the supports and bolts above the tape.
Corroded bolts on the control rod system.
TEPCO really has a problem with lost footwear.
This article would not be possible without the extensive efforts of the SimplyInfo research team
Join the conversation at chat.simplyinfo.org
All content is copyright SimplyInfo.org. Content may also be copyright of other specific original authors or creators and was reproduced here with limited permission. While we welcome the sharing of information or promoting our work, please do so with respect to the large amount of effort and time that goes into our research and analysis. Referring to something or a quote is great, copying it all or in substantial parts is not so great. If you wish to reproduce any of our content in full or in more than a phrase or quote, please contact us first to obtain permission. If you are viewing this content on any website other than www.simplyinfo.org it may be plagiarized, please let us know.