Analysis: Unit 3 Mast In Pool Inspection

TEPCOU3mastmapTEPCO released a new video and handout of the unit 3 mast that fell deeper into the spent fuel pool.

We have processed the video into about 200 still images that can be found here.
The full video of the inspection can be found on our Youtube channel.

TEPCO estimates one end of the mast landed along the east wall with the end resting on a control rod drive rack. The other end appears to be resting tangled in concrete and rebar debris on top of the fuel racks. Portions of the middle of the mast can be seen spanning above the fuel racks by a few inches. What appears to have been the structure that originally held the mast into the fuel crane can be seen partially down the mast.

What is of particular note in the findings from this inspection is that the control rods housed along the east (sea side) wall of the pool. These control rods have considerable damage,with one laying mangled under the mast. The control rods contain halfnium in a steel shell. This damage could have caused them to leak.

 

This diagram shows the structure of a normal control rod with cracks, an ongoing problem in reactor operation. CNIC has reported in the past about control rod cracking problems at Fukushima Daiichi

 

 

bentcontrolrods
The severely bent control rods can be seen in this photo of the mast end as it rests on the control rod rack.

It is not clear if the mast caused this damage or if it was previous damage.

This shows the end of the mast as it sits on the control rod rack bottom lip.

130215_01j001

The top end of the mast resting on a tangle of rebar and debris.

130215_01j041

Telescoping section of the mast, a gap can be seen under the mast showing that it may not all be resting on the fuel racks.

130215_01j075

Another section of the mast showing a gap between the mast and the debris on the fuel racks.

The additional understanding of the location of various structures in the spent fuel pool caused us to revisit the old heat images taken in March and April 2011. This showed the area of the fuel gate and the south wall facing unit 4 of the pool to be the hottest. The image below takes the heat image outline and overlays it on the pool map. The pool map rotated to match the heat map. More investigation is needed to determine if the reactor could have been contributing some of the pool heat via the fuel gate.

U3heat_overmap

 

 

This article would not be possible without the extensive efforts of the SimplyInfo research team
Join the conversation at chat.simplyinfo.org

© 2011-2018 SimplyInfo.org, Fukuleaks.org All Rights Reserved Content cited, quoted etc. from other sources is under the respective rights of that content owner. If you are viewing this page on any website other than www.simplyinfo.org (or www.fukuleaks.org) it may be plagiarized, please let us know. If you wish to reproduce any of our content in full or in more than a phrase or quote, please contact us first to obtain permission.

Editor

Editor, SimplyInfo.org

One thought on “Analysis: Unit 3 Mast In Pool Inspection

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.